iPad Pro (11-Inch) (2nd Generation) Holder Kit

Don't forget to like, share, refine, and boost. Thank you! 

This is a Ram Mount type iPad Pro (11-Inch) (2nd Generation) holder with a 25mm ball. 

Friction holds this iPad securely in place. 

Select your choice of top held or center held sleeve for the iPad. 

Select your choice of holder with or without a pensile holder (Both allow for magnetic charging).

Select your choice of 160mm, 117mm, or 73mm arms with cutouts. Provides for less bite (less friction) but more travel.

Select your choice of 160mm, 117mm, or 73mm arms without cutouts. Provides for more  bite (more friction) but less travel.

Select your choice of long or short base mounts with 6 or 8 inlaid screw holes. 

You will need two ¼in x 2.25in coarse socket bolt and associated washers and butterfly nuts if you select to print your own arms. 

You may (optional) also need 9mmx37mm spring if you would like the arm to automatically expand when unscrewed. 

I recommend using GF infused filament for additional strength.