Search models, users, collections, and posts
Starlink Ver 3 Mount Fence Post
IP Report
Print Profile(1)
0.2mm, standard mode, or 0.2 strength mode PLA or PETG
Designer
10.1 h
1 plate
Open in Bambu Studio
Boost
80
186
3
1
193
45
Released
Description
This is a fence post bracket for a starlink ver 3 receiver dish that mounts on to a concrete fence post. It can be made from PLA or PETG, If you use PLA the items fit snuggly together, If you use PETG you will have to glue the piece together to insure there is no movement.
It is about a 8 to 10 hour print using about 450 grams of filament. You can also use the strength mode of a Bambu Labs pre-set, this will increase rigidity but increases the print time to about 12 to 18 hours and about 750 grams of filament.
This was made as a solution to avoid drilling into a new build house. I am working on a version with a wall mount for future use.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)