Airpod Pro Charging Dock for Lightning USB/USBC

This dock fits Airpod pro (factory and aftermarket) utilizing the lighting cord with USB and USBC ends (USBC doesn't seat completely and can be glued if need be).

You can print the lever on the same plate or as a separate print if you would like it to be a separate color. You just push it in from the inside and the lever protrudes out the front. When the airpods are installed and chargeing the tab is lifted, press down ion it and then grab your airpods. This allows one hand removal, without picking up the base. 

Utilizes design elements from Lars Becker's model (whom kindly approved posting). PLease see their model if you need a base for the fabric cord:

AirPods Pro 2 USB-C Docking Station with AutoEject by Lars Becker - MakerWorld

Several changes were made to accommodate the lighting cord w/ USB, including but not limited to:

• Scaling
• Resizing several locations of the model, including the cord pockets
  • Note: USB cord has a longer head on lightning end and pulls fully down to be fully seated. 
  • Note USB-C cord has a slightly shorter end on the lightning side and should not be pulled completely down into the model (an additional ~2mm spacer may be made later). It can be glued if needed but was rather tight as-is. 
• Thickened the bottom plate to allow the rubber cord to bend at a better angle and for the model to sit flat. 
• Thickened the bottom to alleviate issues with it breaking off (largely due to trying to force lightning cord in prior to alterations).