Search models, users, collections, and posts
PDP riffmaster wall mount for command strips
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
58 min
1 plate
Open in Bambu Studio
Boost
33
100
21
14
278
230
Released
Description
This is a very basic remix from the original model by Hashk4t that I made after I tried hanging my brand new guitar and it crashed on the floor.
I simply added more surface area vertically so command strips could hold the guitar in place without damaging the wall.
I used 4 XL picture hanging command strips but probably 2 would be enough.
Probably any material will be fine but I used Elegoo clear PLA+
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (21)