Search models, users, collections, and posts
Diorama (post-apocalyptic)
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.4 h
1 plate
Open in Bambu Studio
Boost
443
997
20
10
264
90
Released
Description
I designed a small 10x10cm building-complex for a diorama I saw on youtube (link down below).
It is based on one of the models of the guys in the video.
You can see some pictures of the nearly finished diorama in the gallery. Only thing left is the resin (and some killerwhales I found here on thingiverse).
Hope you like it and get some cool dioramas out of it.
Youtube: https://www.youtube.com/watch?v=PGmFOnSGjrA
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK2S
No
Supports:
No
0.2
Infill:
15%
Filament:
Filamentworld PLA
Notes:
The model should print with most settings just fine. I printed it with the listed settings. I'd recommend grey filament instead of the white one I used. I just had no spare grey filament here.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (20)