Search models, users, collections, and posts
Tilted Gridfinity Drawer For Pegboards With Handle
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 10% infill (2 plates to choose from)
Designer
7.2 h
2 plates
Open in Bambu Studio
Boost
325
1173
39
9
620
325
Released
Description
Remix of a tilt drawer I have seen made for honeycomb and skadis but everyone forgets that poor unsung hero, the normal pegboard! I added a mount for a 1-inch spaced pegboard, as well as 1x3 Gridfinity base and a handle for easier opening. No hardware needed, just make sure to print with supports due to the handle and pegs.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (39)