B-Lamp (LED Lamp Kit-001)

Greetings everyone, I created this project for the Maker's Beginner Kit Design Contest

This is a multi-part 3D printed bedside lamp assembled using the LED Lamp Kit-001, a gift from Bambu Lab with my A1 printer purchase.

I printed my lamp using the following filaments: PETG Translucent (Orange 32300) for the top and PLA Matte (Ash Gray 11100) for the bottom.
The third print plate contains a Plate you can print in any other color (preferably PETG Translucent) to alter the emitted light color; I used the standard one included in the LED Lamp Kit

The overall dimensions are shown in the image below (100mm diameter and 160mm height):

Assembly is straightforward; simply follow these steps:

1. Install the switch as shown in the image.

   

2. Coil the excess wire into the groove surrounding the LED housing.

   

3. Place the LED into its designated housing.

   

   I would love to see your color combinations in the comments if you printed the model