MINI-z-top With filament holder
Print Profile(0)
Description
This part is composed of the original default part with an extended arm, designed to hold the filament pully in place while printing.
The installation process can look a little intimidating but it's quite simple.
First, remove the screws in the top part which hold in place the part to the aluminum z-height part, and the screws involved in the tightening of the guide rods as well as the motor screw.
After completing that disconnect the z-height motor from the
motherboard (the wire will be labeled z), and lift the motor until its possible to unscrew the
x axis from the bottom of the z-height screw rod, after that remove the motor and proceed to replace the MINI-z-top part with the new capable of holding the filament.
Afterwards assembly is easier, follow the steps above and start with the threading of the
x axis to z-height screw rode.
This remix is based on
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)