"Experemental" Airzooka

Hi, I wanted to try something a little different, I thought I'd try my hand at making an Airzooka, a popular toy from the naughties here in the UK sold in many gadget shops, sadly they don't seem as readily available anymore, and if you do find one they are quite expensive. This is a simple model and can be printed without supports. 

It will require some tie wraps, some sort form of flexible but not too thin plastic sheet, and a decent rubber band/bands.

To Assemble cut a 30mm hole in the center of the plastic sheet and screw the two “puller” pieces together through the hole. 

Then run the elastic band through the hole in the bottom of the “puller” and secure each end of the elastic band to the lugs on the inside of the cannon body (I find using tie wraps here helps if the elastic band isn't quite long enough).

Now pull the plastic sheet up around the body of the cannon but keep enough sag inside the cannon to allow for pulling back and releasing. Then, secure it with about 4 large tie wraps. and voila

, now you can terrorize the cat/dog…. I mean innocently blow over small paper targets and other things from across the room.. :o)