Search models, users, collections, and posts
Tap Holder for Peg Baord
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.5 h
1 plate
Open in Bambu Studio
Boost
11
24
0
0
14
7
Released
Description
1" spacing peg board with ¼" diameter circles. Pegs work well to attach Tap holder to peg board. No more wasting time printing tool holders that snap pegs off. Pegs print separately and can be reprinted if broken without printing the entire holder again. They fit it very tight and require a decent amount of force to push through holder into peg board. I used standard PLA and seems to be plenty strong.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)