Search models, users, collections, and posts
Groove Life Groove Belt Holder
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
2 plates
Open in Bambu Studio
Boost
26
86
15
3
108
87
Released
Description
Its what it says it is a belt holder for Groove Belts
It's fine to print without the magnet But the magnet does help to keep it from falling off
The magnet needs to be 12.5 mm by 6 mm or smaller
If you use the magnet make sure to use the correct side of the magnet
The pause layer is 39
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (15)