Search models, users, collections, and posts
FobBot - Switchbot Garage Door Rig
Remixed by
Print Profile(2)
0.16mm layer, 2 walls, 15% infill
Designer
2.7 h
1 plate
0.16mm layer, 2 walls, Gyroid 15% infill, Tree (slim),
Designer
2.7 h
1 plate
Open in Bambu Studio
Boost
8
41
7
0
32
13
Released
Description
I wanted a small rig that I could use to hold my Garage Door (Roller Door) remote control / fob, and then remotely operate with a ‘Switchbot’ via a simple button push.
Works really well, repeatable press and fob fits nicely and clicks into place. Print with supports for best results. Remix away!
Usage.
Load remote/fob in cradle and then slide in Switchbot. Set up Switchbot for ‘Press mode’ for 1 sec.
Optional.
Switchbot intergrates with HomeAssistant with a Hub for further automation.
Thanks @iRyanDesign & @Intergalactic101 for the models required to bring this idea into reality.
Prastel TC4S/Topen M12/generic 433MHz 4 button remote magnetic holder
Switchbot Holder
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (7)