Rhodesian Ridgeback Cookie Cutter

I have created cookie cutters of my Ridgeback dog “Naima”

These can be used to cut out standard cookie dough

Recipe link for the cookie dough I used, but any other cookie dough can be used: https://www.wiewowasistgut.com/bester-keksteig-schoko-osterhasen/

Of course, you can also use a dog-friendly cookie recipe and feed the cookies to your beloved pet

The cookie thickness should be approximately 5-6mm, then the ridge will press about 1mm into the cookie dough

If necessary, press the ridge a little more into the dough with your finger to get a nice impression

To remove the cookie dough from the mold more easily, you can use baking spray

The tail is very delicate, it may need to be removed separately from the mold and attached later

However, it worked quite well for me and I got the cookies completely onto the baking sheet

Have fun baking

I would appreciate positive ratings, comments and/or boosts

Original photo:

Cookie cutter:

The result:

I printed the cookie cutter from PLA, PETG or other material is of course also possible
Important for PLA or PETG, the cookie cutter is not dishwasher safe and should only be cleaned with warm water and detergent

Note: Material PLA and PETG are not food safe

2. Print profile:

Original photo:

Cookie cutter:

The result: