A Light Box for your favorite soccer team

Show your true colors, Malmö FF is by far the most successful soccer team in Sweden!

Here are two light boxes, one 10cm wide for LED Lamp Kit 001 and a whopping 20cm wide version for LED light strips (eg. 5V 6500k for a cool white one).

You need black and white PLA and, of course, a lovely sky blue. I used this one (3D Prima, no affiliation)

Print instructions, small (P1, X1)

1. Print the two plates for the small version.
2. Run the connector and switch for the LED Lamp Kit through the hole in the box.
3. Lock cable in place using the small lid like piece. Add a small blob of glue to keep it in place if you wish.
4. Press the MFF shield into the box.
5. Enjoy!

Print instructions, large (P1, X1, A1/A1 Mini)

1. Print the three plates for the large version.
2. Cut the LED strip in sufficient length and insert through the hole on the back of the box.
3. Use the double sided adhesive to mount it inside of the diffusor, on the outer wall shining inwards. Begin taping it at the bottom and continue all around.
4. Lower the diffusor into the box, carefully pulling the light strip cable out of the back of the box. Add a small blob of glue to keep it in place if you wish.
5. Lock cable in place using the small lid like piece before the diffusor rests all the way in. Again, add a small blob of glue to keep it in place if you wish.
6. Press the MFF shield into the box.
7. Enjoy!