Demon Slayer Lightbox - Free 3D Print Model

Search models, users, collections, and posts

3D Geek

Household>Decor

IP Report

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 2 walls, 15% infill

Designer

7.6 h

2 plates

4.3(35)

Open in Bambu Studio

Boost

129

232

334

197

Released

Description

First attempt at a lightbox for my daughter who loves anything anime.

Update 12/26/2023: Uploaded revised files for hanging and standing versions of this with new design for putting back plate on with ease.

Standing Version : https://makerworld.com/en/models/108644#profileId-116014

Hanging Version : https://makerworld.com/en/models/108642#profileId-116009

demon slayer

lightbox

demon slayer lightbox

Comment & Rating (53)

@AlessandroFue

Boosted

Spectacular Thank you

The designer has replied

Show original

@3DGeek

👌

@user_783188517

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

I printed this for my little nephew on my A1 and he absolutely loved it! I do think it could use some work on how well it snaps together. All of the zig zags on the perimeter make it hard to get it together.

The profile uploader has replied

@3DGeek

Yea it is a pain. I made a few different versions that don't have that issue. I'm glad he liked it and that you were able to get it together. I just sand it down a little when I need to make one for someone now.

@cantinho.da.de

Print Profile

0.2mm layer, 2 walls, 15% infill

top model

@ElZama

Print Profile

0.2mm layer, 2 walls, 15% infill

perfecto

@user_2728731819

Print Profile

0.2mm layer, 2 walls, 15% infill

perfect impression the only downside I encountered is that the assembly is not quite perfect I had to force it a little

Show original

@chazbarros

Print Profile

0.2mm layer, 2 walls, 15% infill

Awesome but requires a lit bit of sand and grinding to attach both parts

@BambooDav

Love the design! but the lid was way too difficult to put on as it didn't align properly. Had to cut a lot of tabs for it to fit. Also the hole on the bottom for the cord to come out makes the lightbox tilt making it not sit straight. over all i do love the design, keep up the good work.

The designer has replied

@3DGeek

This was my first attempt at it. When I get the chance to redesign it I will also put the hole on the back plate with the Usb C connector dimensions. 👍

@3DGeek

New versions are up if you would like to check them out! Thanks for your feedback on the original!

@ForestKira

Print Profile

0.2mm layer, 2 walls, 15% infill

@PrintSomeMore

Print Profile

0.2mm layer, 2 walls, 15% infill

Came out fine with a .4 nozzle, at .12. However attaching the back plate to the front was a nightmare, I had to snip off various pieces of the back plate so that it would mate with the front. Perhaps redesign the back plate so that it fits into the front easier. Otherwise its good.

The profile uploader has replied