Search models, users, collections, and posts
Oneway Tenon Gauge
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
3.5 h
1 plate
Open in Bambu Studio
Boost
6
30
6
0
33
9
Released
Description
Tenon gauge for 2 and 4 inch vicmarc jaws, but should work for any of the same size. Just snap over the Oneway live center and allow it to rest on the tool rest. Slip a pencil in the appropriate groove to get your mark. From middle out, 2 inch tenon, 2 inch mortise, 4 inch tenon, 4 inch mortise. Tenon is sized for roughing so just a little large. Mortise is minimal for those sized jaws. When done, just take it off and place it on the hanger or slip it into your turning smock.
NEW: Customize for your own jaws. https://makerworld.com/en/models/2169748-oneway-live-center-tenon-gauge
PLA, PETG or like. Stiff TPU should be okay: I just have not tested it.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (6)