Minisforums UM890 Pro Vented Lid - Free 3D Print Model

Search models, users, collections, and posts

bri0nac

Hobby & DIY>Electronics

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 6 walls, 25% infill

Designer

1.3 h

1 plate

5.0(2)

Open in Bambu Studio

Boost

Released

Description

The miniforums um890Pro has good cooling but I wanted to open up the lid for better air flow. The lid is a snug fit but you can press fit the magnet listed below for a secure fit.

Parts Needed:

4 - 6x2mm magnets (optional)

Project created in OnShape.

minisforum

mini personal computer

fan

vent

cpu

Comment & Rating (5)

@Rushy_Rush

Boosted

Print Profile

0.2mm layer, 6 walls, 25% infill

Prints perfect and fits perfect, thanks!

@N0p3Mark

Is the heat a factor for your PLA print of this model? I’m curious if I should use PETG because that little PC gets hot sometimes.

@Klyzore

Replying to @N0p3Mark :

I don’t think it will matter, Pla has a melting point of 160 °C while computers will should only reach 95°C (without damage or thermal throttling).

@Klyzore

Print Profile

0.2mm layer, 6 walls, 25% infill

fits well without magnets and looks nice

@trei_99

Was improvement achieved after installing the lid

Show original

No more

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.