Search models, users, collections, and posts
the witcher - wild hunt logo
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
4.1 h
2 plates
AMS Support, 0.2mm layer, 2 walls, 15% infill
4.7 h
2 plates
Open in Bambu Studio
Boost
46
77
16
5
73
44
Released
Description
As a big fan of this series, I really wanted to have a sign or board on my desk. There were already various fan articles, but I wanted a kind of wooden board with grain. That somehow looks more authentic to me. So I created the board myself and embedded the lettering.
Can be printed completely without supports. However, you should set up a break in the slicer in the corresponding layers so that you can change the filament. I placed the red claw marks in the middle 1.2mm higher than the white writing. This means that with a layer height of 0.2 there is enough space to apply the red filament.
The board also has two holes, which is correct and intended. Because the board should look a bit jagged.
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (16)