PS4 Controllers Stand
Copyright Claim
PS4 Controllers Stand
Boost
61
89
74
Print Profile(2)
0.16mm layer, 2 walls, 15% infill
Designer
2.2 h
1 plate
0.16mm layer, 2 walls, 15% infill
Designer
10 min
1 plate
Boost
61
89
74
1
370
452
Released
Description
This is a remix of the “PS4 Controller Stand” by Andreunto.
It to fit 2 controllers.
Best way to print it is on the side (no supports needed.)
There are 3 files: 1. Stand for 2 controllers; 2. PS logo
Print Settings
Rafts: No
Supports: No
Resolution: 0.2
Infill: 30
Credits:
Sufurka
Comment & Rating (74)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
perfect !
The designer has replied
1
Reply
Nice! Blue and white looks even better.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Molto carino
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Just what I was looking for!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
It works with the PS4 Controller as well as with the Nintendo Switch Pro Controller. Although the Switch Controller does not fit perfectly it works fine.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
nice model, works/fit pertectly
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
it was perfect
(Edited)
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
printed this on A1... it look great..I've some warping a a corner so maybe a brim should be added. Other than that ..wonderfull !
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Printed in PLA.
It warped on me a few times, so i added a brim.
Looks good and keeps the table organised.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
very nice model, profile worked finde, thank you
(Edited)
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Printed in PLA using a brim.
0
Reply
License
This work is licensed under a
Creative Commons AttributionRemixes (3)
Click to see more
© 2024 MakerWorld