Search models, users, collections, and posts
M5 Stick Rugged Case
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
31 min
1 plate
Open in Bambu Studio
Boost
43
57
9
1
197
104
Released
Description
This is a case for the M5 Stick Plus 1 or 2
I prefer printing it in PETG as the buttons are a little more sturdy but PLA should work just fine! Line up the little notches and it should snap together tightly. Hole on the back is for pushing out the device if needed.
includes a hole for the IR Emitter
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (9)