Basic Pokemon Box by Olive and Chips

Olive and Chips

Tools>Organizers

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

regular strength and stuff

Designer

1.7 h

1 plate

5.0(1)

Open in Bambu Studio

Boost

Released

Description

its a box for cards specifically for Pokémon cards

pokemon

box

basic

Comment & Rating (7)

@mtaphorn

Lid broke at the hinge after first open and close test. Needs thicker lid hinge ring and top of lid has rough surface due to orientation and supports. Needs to be oriented in a way to avoid exterior surface being rough.

(Edited)

The designer has replied

@OliveandChips

Thank you for your feedback, I've only printed it in pla-cf so I've never had any problems with breakage and I can't really reorientate the lid because of the hook that allows it to close, and supports wouldn't work in the hinge, unless you may have an idea? The lid for me was smooth, you can still see some lines though it isn't too ruff. Also the tolerance might be too tight with regular pla for the hinge or not strong enough to take the supports. Thanks again for the feedback!

(Edited)

@mtaphorn

Replying to @OliveandChips :

Thanks for the response. I used PLA-AT that is supposed to be stronger than PLA. Not sure why it failed. I was thinking about trying to edit the file so that the lid could be printed as a separate object on the plate with a C ring that snaps on the cylinder of the base. That would eliminate the tree supports and make it easier and faster to print...

@OliveandChips

Replying to @mtaphorn :

Good Idea!