RC Car stand 1:10 1:8 V2

V2 of my remix based on this model:
https://makerworld.com/en/models/827666?from=search#profileId-771551
It accomodates perpendicular to car bed posts, that hold car better in place.
Taller by 2cm tower, that allows bigger/longer car to “float” above the surface that stand stays on.
Model on stand is 1:8 CEN Racing Ford Puma, so anything similar scale should sit fine.
If you have V1 just print the side panels (everything fits fine).

If you print the model as whole, remove the initial nozzle cleaning strip from bed on plate 1 in order not to have this strip fused with base of model. If you forget to do it, it is still easy to remove it.

Brackets that hold the side panels have square and circle on sides, put them accordingly on panels for ease of assembly (that is from original model made by original author).

V1 was ok once you placed the car properly. This version allows car to “fall in place” way easier, and model is less prone to slip off while positioning the car.