Doctor Who and Rose Hueforge
Print Profile(1)
Description
Here is a HueForge made of Doctor Who with his companion Rose.
I printed this with Bambu Lab PETG HF filament. I hope you enjoy!
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.08mm
The Model is 200x200mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm
Swap Instructions:
Start with Black
At layer #17 (0.72mm) swap to Blue
At layer #22 (0.92mm) swap to Gray
At layer #26 (1.08mm) swap to Red
At layer #27 (1.12mm) swap to Orange
At layer #34 (1.4mm) swap to Yellow
At layer #41 (1.68mm) swap to White for the rest.
Quality -
Layer height
Layer height: .04
Initial layer height: .08
Seam
Seam position: Back
Strength -
Walls
Wall Loops: 1
Top/bottom shells
Top Surface Pattern: Montonic
Top Shell Layers: 5
Bottom Shell Layers: 5
Internal solid infill pattern: Montonic
Sparse infill
Sparse infill density: 100%
Spares infill pattern: Rectilinear
Others -
Prime Tower
Width: 30
Prime volume: 30
Brim Width : 2
Note: I get a warning about floating regions. I ignore the warning, and the plate has printed perfectly fine each time I have done this.
Consider supporting me all memberships will have the rights to produce and sell my prints.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)