Tiered Dual Synth Stand

I originally created this for 2 Arturia Microfreaks. I own two of these synths, which are absolutely amazing. But these stands can be used for most synths about the same size pretty easily. 

I wanted a way to minimize desk space and keep them at eye level for easier control and access. The 3mf file contains the layouts for each side of the stand in various parts. I used 8/23" machine screws to bolt them together very easily and rectangular printed rods which should slide in each side of the stand with minimal force. I had to tap them with a hammer lightly and they held together well. If not when you print them, just add a bit of your favorite plastic glue. On the back of each rail are square holes designed specifically to hold cables in place via zip ties.

I recommend printing these with higher infill for less flexing and adding some type of rubber base a the bottom so they don't slide around on your desk or table.