Search models, users, collections, and posts
Wyze V3 tail
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
22 min
1 plate
Open in Bambu Studio
Boost
1
4
0
0
1
0
Released
Description
I made this to go along with my sheep face. It's basically the same frame, but with a little tail. Print it as is, then while it's still warm the tail can be shaped and bent. If it cools it can be heated with a blow dryer, etc. It's only 2mm thick so is easy to soften.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)