Anti Vibration Feet X/P series (X2D/P2S)

This is made for regular 95A TPU, NO AMS!.

I tried the ones from Bambu Lab but they fell out and the printer still rocked around too much for my taste. These allow just enough that it still shakes under hard load, just not as much. This is to lessen wear and tear on the moving parts as the energy from shaking has to travel through the gantry to the feet. The weakest points are all of the stuff you don't want to wear down. I choose a compromise between all of these factors.

This is a slow print to maintain the intricate inner passages of the feet, so please plan accordingly. This print will stick to the build plate very well.

I included a 4 pack of these so you do not have to stop and reset to get all 4, it is a slower print than just printing one at a time FYI.

These are meant to be mounted on a solid surface, if your printer is not on a sturdy surface this will not cancel out all the vibration.

If you have no other choice place a cement paving stone under your printer, as seen in my picture.