Winter Glow - Cozy Christmas Bookmarks Set

If you want to sell prints of this model, as well as all of my models - future and past
Subscribe to My Patreon:

Or Subscribe for a commercial License Directly in Maker World:
 

Winter Glow is here to light up your reading this holiday season! 🎄 Imagine curling up with a good book while these bookmarks whisk you away to a snowy village where the stars sparkle brighter than the cookies on Santa’s plate 🍪✨. Each one is like a little postcard from a winter wonderland, complete with glowing windows and cozy vibes. Just don’t blame me if your book gets jealous of all the attention your bookmark is getting! 📖❄️

For best results use 0.2 nozzle if possible, but 0.4 is also works great (The pictures show a model printed with a 0.2 nozzle)
The design allows for printing with simple color changes at layer, which saves a lot of filament!

• NOW WITH 0.2 NOZZLE PROFILE READY FOR DOWNLOAD - USE FOR BEST RESULTS
   

USE A LIGHTER! - a quick pass with a torch on the printed parts will get rid of the inevitable stringing that comes with this type of models.
 

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA EryOne Galaxy Black Transmission Distance: 0.1 / Amazon
PLA EryOne Matte NAVY BLUE Transmission Distance: 1.5 / Amazon
PLA+ Jayo Sky Blue Transmission Distance: 4.4 / Amazon
PLA 3D Jake Eco White Transmission Distance: 2.5
PLA Geeetech Silk Gold Transmission Distance: 0.7 / Amazon

Color Pallete (5 Color Version):

Color Pallete (4 Color Version):

Swap Instructions(5 Color Version):

Start with Galaxy Black
At layer #8 (0.73mm) swap to NAVY BLUE
At layer #10 (0.89mm) swap to Sky Blue
At layer #13 (1.13mm) swap to White
At layer #17 (1.45mm) swap to Silk Gold for the rest.
Swap Instructions(4 Color Version):
Start with Galaxy Black
At layer #8 (0.73mm) swap to NAVY BLUE
At layer #11 (0.97mm) swap to White
At layer #17 (1.45mm) swap to Silk Gold for the rest.

How to do more than 4 colors on a single AMS?

To use more than 4 colors with a single AMS is pretty simple when it comes to HueForges.

Always start the print from either Bambu Studio or Bambu Handy App - This will allow you to map the rolls of filaments to a certain slot in the AMS:

Now map the first 4 colors (which should already be inserted in the AMS to Slots 1 - 2 - 3 - 4
Once thats done move to maping colors 5 - 6 - 7 - 8 to respectively AMS Slots 1 - 2 - 3 - 4 again!

This will allow you to Change the rolls of filament once the printer is done with that color.
For example, in the picture above once we are done with the Black color (Which is usually first) we are going to remove the black roll (you can do that while printing) with White, then once Charcoal Black is done we are going to change that to Red, Dark Gray to Yellow and we are done. ~ You can do that with as many colors as you need!
YOU CAN PLACE A PAUSE ON THE LAST LAYER OF COLOR 4 TO AVOID HAVING TO BABYSIT THE PRINTER. ONCE PAUSED CHANGE 1-2-3 WITH 5-6-7 AND RESUME. IF YOU NEED MULTIPLE PAUSES YOU CAN DO THAT TOO

Drop me a follow!🤜🤛