Search models, users, collections, and posts
BAOFENG AR-5RM Cupholder Mount
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 10% infill
Designer
3.3 h
1 plate
Open in Bambu Studio
Boost
229
735
31
17
497
303
Released
Bill of Materials
Bambu Filaments
Select all
Description
Basically a remix of regsix7's model for a UV-5R cupholder I found on Thingiverse. This will fit the new BAOFENG AR-5RM. Just slide the belt clip into the top and it clicks into place. Should fit most cupholders nicely. Still can work as a clunky desk mount as well. I used ASA since I print a lot of it, but any material will work. However if you're going to be leaving it in a car, I would try and stay away from PLA. NO SUPPORTS NEEDED! Enjoy!
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (31)