Search models, users, collections, and posts
Print Profile(1)
0.16mm layer, 5 walls, 15% infill
Designer
2.3 h
1 plate
Open in Bambu Studio
Boost
4
12
0
0
7
3
Released
Description
Tamper for Flair espresso, leveling and with spring.
inspired by this tamper and borrowed parts from it/ uses same spring.
Only fits Flair Classic (39.4mm portafilter) Can make other sizes if there is interest.
Print in whatever you are comfortable with, printed in PETG 0.16mm, 6 walls, tamper down is printed with 90% infill and 6 walls, archimedian cords on bottom for better surface.
0.16 should suffice and PLA should hold pretty good.
Mid piece needs support, use orientation according towards what your printer prints best, inner part should be relatively clear so that it fits properly.
Assembly:
Tamper
Mid piece
Spring on top of the mid piece
Screw in cap
Enjoy your tamper!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)