Ulanzi LT028 LT024 LT023 Godox Softbox adapter

I wanted to use a Godox softbox with a Ulanzi LT028/LT024/LT023 LED lamp - this comes with a “mini bowens” mount but doesn't seem to be fully compliant with other equipment specs out there. This adaptor will allow S Type Bowens mount to fit on the light housing. I printed it in PETG in case there was any danger of heat distorting a PLA version but it might be fine. I have used it with both 35x35cm and 60x60cm Godox softboxes with no issues. I don't have anything bigger here to test it with but I've used it for several hours continuously with no deformation or slippage. The tolerances could possibly be tightened up for the Mini Bowens section as its a slightly loose fit but once the softbox is attached there's no real issue with it moving. Needs small supports under the tabs but nothing too hard to remove.

Have now printed it in PLA-CF and it works fine as well - no heat issues at all.