9MM EDC Stand

This is handier than pockets on a shirt! Not sure why I can't rate it. Printed in PETG and work great, also works fine with my .357

Fresh off the printer! The details on this model are insane well balanced, strong and won’t tip over. love it!

Did not change a thing and works great for a .40S&W if anyone was curious. Thank you!

ANAZING! Such a cool look minimalist meets EDC i keep mine on my night stand and another one in my kitchen printed fine i broke the first one because i was to impatient and didn’t let it cool down enough before i tried to take it off the plate and the vertical column just broke XD 200% my fault great model!!

Used Petg and it holds very well had a few blemishes but holds item well with magazine.

Sturdy

this is a great starting point my comment would be a second version with a much larger base plate maybe five to six inches in diameter or even offset with the pin at one end and a large diameter to the one side allowing for more stability my thought is just sitting on the floor next to the bed in a ready position

Fresh off the printer! The details on this model are insane!

would love to have a wall mounted version to keep my EDC in my holster and hung up…away from my little ones hands. maybe when I get time when he’s older I’ll take a crack at designing on myself.

came out perfect and will work with 380acp, .38 and 357 barrelled pistols. printed 4 but may make more. I love simple designs that just work and this is one of them!