Elegoo Saturn 3 & 4 heater mount - Free 3D Print Model

Search models, users, collections, and posts

Remixed by

cdelasbour1

3D Printer>3D Printer Accessories

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 6 walls, 15% infill

Designer

4.2 h

1 plate

5.0(3)

Open in Bambu Studio

Boost

Released

Description

I've remixed two completely different users models, merging them into one.

4cmclean Model - I trimmed of a few pieces models and enlarged the depth for more stability since it's mounted to the printer lid. Also added Cable Management holes to the right and bottom to rou

Boost Me (for free)

Any boost would be helpful. Thank you in advance

te the power cord out the back.

Pierky81 Models - I removed the piece for the Chitu Heater, add recess to that same mod plate so the heater support can be glued ( I used super glue) perfectly in place. Reduced the hole size on both plates to use M3-0.5 x10 mm screws without heat inserts. The screw holes are smaller then the metric screws I used and so it would be a tight fit. You may need to drill the holes a little larger or mode the file.

I used a similar heater to this one: https://www.amazon.com/AUERVO-Lightweight-Thermostat-Temperature-Controller/dp/B0BRK7K2VW/ref=sxin_16_pa_sp_search_thematic_sspa?content-id=amzn1.sym.86e26e76-8138-47f9-9d58-a550bcf8f353%3Aamzn1.sym.86e26e76-8138-47f9-9d58-a550bcf8f353&crid=FWSPWZ56PFNV&cv_ct_cx=3d+printer+heater&keywords=3d+printer+heater&pd_rd_i=B0BRK7K2VW&pd_rd_r=ac538462-5bc3-41e1-8d6b-798ee38403c9&pd_rd_w=s1i0A&pd_rd_wg=ue7ZY&pf_rd_p=86e26e76-8138-47f9-9d58-a550bcf8f353&pf_rd_r=2HCAT1T36XT4HKJQQWZ4&qid=1733776474&sbo=RZvfv%2F%2FHxDF%2BO5021pAnSA%3D%3D&sprefix=3d+printer+heater%2Caps%2C99&sr=1-1-6024b2a3-78e4-4fed-8fed-e1613be3bcce-spons&sp_csd=d2lkZ2V0TmFtZT1zcF9zZWFyY2hfdGhlbWF0aWM&psc=1

Comment & Rating (8)

@CZ2128

Boosted

You're a lifesaver, I was planning to this exact same thing, but I'm glad I found your model It was a small hassle to set it up, but it's working as intended Mounted it on my Saturn 4 Ultra PS. I cannot rate since I used different material and setting than the print profile, but here's some boost tokens Thanks again!

(Edited)