Search models, users, collections, and posts
Anycubic Photon Mono 2 Riser
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 15% infill
Designer
4.6 h
1 plate
Open in Bambu Studio
Boost
23
27
3
2
43
6
Released
Description
Content has been automatically translated.
If you are a resin printing enthusiast and own an Anycubic Photon Mono 2, this accessory is a must-have!
Especially during winter, maintaining optimal printer performance requires keeping the resin at the ideal temperature. This often necessitates the use of heaters (DIY or commercially available), but their power cables can be challenging to route without compromising the lid's stability.
Therefore, I have designed a riser that elevates the lid by 15 mm, allowing the heater cables to exit from the back of the printer.
The model is engineered to attach to the plastic screws on the platform and features supports on all four sides to prevent accidental lid slippage.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)