Gridfinity base for Makita Mbox

A gridfinity base on top of the makita mbox inlay made by @FLAM3S

Given the various notches in the mbox, I didnt think it was worth to cut the base into 4 sections instead of 2 so that it would fill the whole bottom as you wouldn't win any extra gridfinity squares with that.

Although this design works ok, if I would do it again I would probably align the gridfinity squares to the left side (instead of centering them) and I would cut off another 1-2mm from the makita inlay so the gridfinity sits more flush with the makita bottom.

--edit--

Alternatives:

• https://makerworld.com/en/models/554145
• https://makerworld.com/en/models/675897
• https://www.printables.com/model/325506-gridfinity-makpac-systainer-baseplate