relOJos (cross-eyed clock)

Tired of the usual designs...

here's a…

Cross-eyed Watch!

This original clock will tell you the time through its gaze!
The left eye will indicate the hours of the day (and night), while the right eye will indicate the minutes.
The design is intentionally kept "clean" but it will certainly be an impactful clock!

Example:

"relOJos" in action... 1 Hour Timelapse:

- . - . - . - . - . - . - . - . - . -

Its installation is very simple:

1) Place the rubber washer.

2) Insert the mechanism from the inside.
3) Insert the metal washer.
4) Tighten with the appropriate nut.
(replicate for both dials).

5) Pair the black sphere above the white sphere, keeping the white dot on the outside.
6) Flatten the pins using a lighter and a flat screwdriver. (Children, have your parents do it).

7) Insert the dial with the longer pin on the left side (hours)
while the dial with the shorter pin will go on the right side (minutes).

8) optional Insert 34cm of TPU filament (1.75mm), inserting it into the slot below using a large flat screwdriver.

9) optional Insert the special "easy removal" tab
10) Insert the batteries paying attention to the polarity direction.

Wait for the various hours of the day to discover new hilarious expressions!!

- . - . - . - . - . - . - . - . -

P.S.

You can also print the main body without a brim

if you blindly trust your "SuperGrip" printing plate! ;)

Warning:
This clock requires 2 Bambulab clock mechanisms KIT011

----------------------------

Disclaimer:

This work by TheMiguelBi is licensed under Standard Digital File License

Strict non-commercial, personal use only license.

You are not allowed to Remix or Copy this model to other 3D printing websites without my permission.