Search models, users, collections, and posts
Wiremold wire channel
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
37 min
1 plate
Open in Bambu Studio
Boost
6
9
0
0
18
8
Released
Description
I was putting up metal wire channel and the where it connected to the source I wanted it to look a bit cleaner so this is just an extruded cross section of the wire chase. At this size I was able to click it over the wire chase and it presto it looked much cleaner. Use carefully of course, it's not metal.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)