Search models, users, collections, and posts
PWHL Logo Ornament
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
39 min
1 plate
Open in Bambu Studio
Boost
17
22
1
1
21
12
Released
Description
This is an ornament based on the logo of the PWHL. It is 3" in diameter and has a built in hole for attaching hanging hardware. I experimented with ironing on the logo only and it produced some nice results after dialing in the settings. If you want to try for a different look try using Archamedic Chord for the top surface finish instead of the traditional Monotonic Line.
Filaments used:
Bambu Lab Basic PLA Black
Bambu Lab Basic PLA Purple
Bambu Lab Basic Silver
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (1)