Gift box version of the Little Debbie Christmas Tree! This is a remix of the ornament version that I previously released. If you'd like to pack Christmas Tree snack cakes in the gift box, 5 easily fit. Unfortunately, they cannot be stacked. However, a layer of Little Debbie brownies would fit under the trees.

Changes that were made to the original:

• 375% of the original size
• Split in two
  • Removed lip from the lid
  • Shelled base section
    • 5mm side walls
    • 2mm bottom

***WARNING***

This is not a small object! My print time was about 19 hours and I used just over 500g of filament. 290x216x69mm

Print Settings

The model is rotated 45 degrees to allow it to fit the build volume of more printers. This will fit on the Prusa XL and the Bambu Lab X1/P1 series printers.

Supports are required for the lid. If the lid is close in size to the max print area, the supports may exceed that print area. To solve this, I switched to tree supports. They tend to stay closer to the object.

Buy Me A Coffee

The following filaments were used in the pictures above:

• Bambu Lab Matte Ivory White PLA
• Bambu Lab Matte Scarlet Red PLA
• Bambu Lab Matte Grass Green PLA