Kobra2-Max Printer Filament Holder Modification

The side-mounted filament holder on the Kobra2-Max 3D printer is quite inconvenient and prone to tangling, so this modification moves the holder to the top for improved ease of use.

1. Hardware required:

M3*8 cup head screws *2

European standard 20-M3 elastic nuts (ordinary T-nuts should also work, but haven't been tested) Elastic nuts are recommended

M4 nuts, thin or thick (thin ones look better)

The original mounting screws for the holder can be reused; if they are too long, you can replace them with shorter M4 screws.

2. Print orientation:

As shown in the image

3. Print head considerations:

Simply insert a filament tube approximately 9 centimeters long into the print head. A portion of the original feed tube can be cut off, as shown in the image.

That's all there is to it.