Search models, users, collections, and posts
Govee Permanent Outdoor Lights 2 and Elite Clips
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
2.2 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
3.1 h
1 plate
Open in Bambu Studio
Boost
63
109
35
20
260
175
Released
Description
These are for the Govee Permanent Outdoor Lights Elite from Costco. The model is H805C. There are two models. One has two screw holes while the other has one. The single screw clip allows users to put the LED module directly against a surface and still have security of a screw. The fit is snug so they do not fall off during installation. The screw holes are 4mm and were designed to use gutter screws that had a head diameter of 8.5mm. Using rapid PETG on a P1S, I can print 25 doubles or 48 singles in around 2 hours.
Print in PETG for outdoor use.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (35)