Search models, users, collections, and posts
TCG Card Organizer
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4.8 h
1 plate
Open in Bambu Studio
Boost
20
42
0
1
31
15
Released
Description
TCG card organizer, you can connect multiple card organizers side by side, I recommend printing it as per the profile with the supports under the front part of the bottom of the card slots, but the print also comes out well with minimal supports only on the lower part of the rear step
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)