Search models, users, collections, and posts
Eurorack Side Rail Brackets
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
1.4 h
2 plates
Open in Bambu Studio
Boost
28
90
4
4
82
42
Released
Description
Included are two styles of side brackets for your own DIY Eurorack case and its Gie-Tec rails. Both the 3U and 1U (Intellijel) brackets include countersunk holes for M5 flathead screws for mounting the rails, and M3 flathead woodscrews for mounting the brackets to a case.
Each bracket has been lengthened by an extra 1mm from the Doepfer and Intellijel specs to accommodate for shrinkage in the 3d printing process and to allow for some wiggle room on the modules.
Slots near the rail mounting screw hole allow you to slip in a 3mm threaded strip or square slide nuts with the rails already mounted to the brackets.
I've uploaded the original Fusion 360 models as well if anyone needs to make changes or wants to create a remix.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (4)