Cosmo JrTrack Watch Stand Charger

Ok, I looked. There wasn't one. Needed to rectify asap. So, this is modeled after the beautiful Apple Watch Charger made by Reckit.

Hopefully the pictures make it perfectly clear; You print this (I used tree supports, but, if your bridging is king you might get away without - I didn't dare), and then you squeeze that charger into place. The fit is nice and snug but not “how the crap do I put this in” snug.

The cable Cosmo gives you for the JrTrack watches is embarrassingly short, and you'll find about 12 inches or so available after routing the cable through the cable trough. A usb “A” extension cable is recommended unless your lamp has a USB port on your nightstand or something.

I printed mine with 0% infill. After consideration, I made the 3MF profile that way. It really doesn't need anything on the inside. You'll likely need to change your nozzle from 0.6 to whatever yours is when you open the file since that's what I was using.

Good luck! Hopefully this helps someone!