Search models, users, collections, and posts
Crane Spreader Bar
IP Report
Print Profile(2)
0.2mm layer, 3 walls, 10% infill
Designer
33 min
2 plates
A1 Mini Version - 0.2mm layer, 3 walls, 10% infill
Designer
37 min
2 plates
Open in Bambu Studio
Boost
83
208
22
3
225
135
Released
Description
This is a spreader bar for a model crane. I designed this to work with m3 screws on the buckles and to be easily printable on an FDM printer, while being strong enough to hold your scale loads.
Make sure you rotate the buckles so they're flat on the printer bed. You can probably print the bar without support, if you trust your printer's ability to do bridging, but I played it safe and used supports. It's meant to be printed right side up, and is fashioned after a real world design that has little tabs to help the bar sit right side up.
-------
If you like my work, consider showing your love by Buying me a coffee. Additionally, if you're looking to sell prints of my design, please check out my Patreon page for more information.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (22)