Search models, users, collections, and posts
"Money Syringe"
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 20% infill
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
107
374
65
10
370
259
Released
Description
Content has been automatically translated.
"Money Syringe" as an original packaging for monetary gifts.
Roll up one (or more) banknote(s) and insert it into the screwed-on syringe body. Screw the tip back on - done…
Assembly:
The "Plunger" is pushed from the inside through the recess (use tweezers if necessary). The "Plunger Plate" is then glued to the "Plunger" with superglue.
Material: PLA
Layer height: 0.2
Perimeter: 3
Top/Bottom layers: 3
Infill: 15%
Supports: only for the overhanging edge of the "Tip"
Created with FreeCAD 1.0
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (65)