Trifolium Lamp

- A PDF manual is included, to help assemble this lamp. -

- Printer size: -

Depending on what size print bed you have, you might want to see what size might be printable on your printer, then the following options for printing the ribs i recommend is:

For larger printers: Rib A & B single piece

For smaller printers: Rib A bottom & bottom + Rib B top & bottom + lock pin

- Bill Of Materials: -

3D Printed Parts:

For smaller printers :

(the Lock Pin these are only needed to assemble the top and bottom part of Rib A & B)

Filament for printed parts :

Non Printable Parts:

https://www.ikea.com/gb/en/p/hemma-cord-set-white-10386577/

(A low wattage is preferred, to prevent softening the printed parts, due to heat dissipated from the bulb Max diameter 80mm)

• Pictures of the fully 3d printed version vill be uploaded, as soon as i have printed all of the parts, for now, it is only in white, since that was what i had laying around, but i can comfirm, that everything fits together with no problems, so far.

- Update: 09/10/2023 -

- The manual have been updated and corrected.