Search models, users, collections, and posts
45° Filament Cutter
Remixed by
IP Report
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
40 min
1 plate
0.2mm layer, 2 walls, 15% infill
54 min
1 plate
AMS PTEG-HF 0.2mm layer, 2 walls, 15% infill
1.1 h
1 plate
Open in Bambu Studio
Boost
127
395
113
38
558
363
Released
Description
Content has been automatically translated.
A remix of BC Design's excellent filament cutter to enable a 45° filament cut.
Ideal for the Sunlu filament connector.
Original Model: https://makerworld.com/en/models/16194#profileId-15180
As with the original, requires:
1x original Bambulab filament cutter
2x M3 x 30mm carriage bolts
2x 4 x 25 mm springs
Assembly identical to the original;
- Screw in the two bolts from below, then insert the springs.
- Insert the cutter into the top section and insert a strand of filament to lock it in place. Cut flush.
- Insert the top into the bottom and screw it in. Press firmly downwards and tighten the screws so that they are just inside the lower piece.
Support/guide for the Sunlu filament connector with filament guidance/retention:
https://makerworld.com/en/models/842973#profileId-789556
“Box” version of the filament connector support/guide: https://makerworld.com/en/models/854472#profileId-803440
Boost Me (for free)
Like it? Boost it!
Thank you :)
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (113)