M84 Flashbang Stun Grenade with Flying Handle

Summary

This is a 1:1 scale model of the famous M84 Stun Grenade, better known as a Flashbang. This grenade has articulated pin and handle – the handle can be optionally configured ot be spring loaded and fly off when released. This grenade is used to stun the occupants in a room or small area to assist with hostage rescue, room clearing, etc. Almost everyone has seen a movie or played a game that had a flashbang in it.

The model is easy to snap together, no glue is required.

Spring options (for flying handle)

1. Metal Spring (recommended) – if you have a metal spring, even a pen spring will usually work, then print the metal spring profile.  It is designed to work with the Bambu Store's 0.5x7x12mm spring (linked lower on the page).  If you use a pen spring, you can usually cut it in half and get two springs.
2. Plastic Spring – if you don't have a metal spring, but still want the handle to fly off, then print the plastic spring profile.
   1. If the spring eventually wears out, just print a new one and pop it in.
   2. Don't leave the spring under tension when not using it as it will wear out much faster.
   3. Avoid Matte and Silk filament for the spring itself, Basic and Metal work better.
3. No Flying Handle - if you don't want the handle to fly off and just want a grenade model, simply print either version and don't put in a spring.

Filaments used

• Matte Blue
• Silk+ Silver
• Silk+ Red
• Overture Silk Gold (Amazon link)
• Polymaker Metallic Chrome (Amazon link)

[v2] Metal Spring Version Assembly

1. Insert the peg into the silver/red inner part of the grenade as you see below.

2. Then slide the inner grenade into the outer grenade, push down until the peg snaps into place.

3. Insert the tiny peg/plunger into the grenade topper.  Make sure its oriented as you see below and that it sticks out the bottom.

4. Then insert the metal spring the same way you inserted the plunger/peg.

5. Lastly, screw the top onto the grenade body, doing this upside down is much easier.

[v2] Plastic Spring Version Assembly

1. Insert the peg into the silver/red inner part of the grenade as you see below.

2. Then slide the inner grenade into the outer grenade, push down until the peg snaps into place.

3. Next, insert the printed peg into the topper, make sure it sticks out the bottom, if not turn it until it does.

4. Lastly, screw the top onto the grenade body.  Its much easier to do upside down.

[Older v1] Assembly

( ! ) Do not sell my prints — I have not authorized selling prints.  If you sell my prints on Etsy, Amazon, eBay, etc, I will find out.

This 3D print is intended for decorative purposes only and is not suitable for children. Small parts may present a choking hazard and edges may be sharp. By printing this 3D print, you assume all liability for any harm to yourself or others resulting from its use.