Search models, users, collections, and posts
BlitzWolf BW-AH1 Charging Stand
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
2
0
0
0
5
0
Released
Description
A simple charging stand for the BlitzWolf BW-AH1 smartwatch.
I printed mine with 15% infill and 0.2 layer height sitting on the flat side and it came out just fine.
There are 2 zip tie slots on the right side and 1 next to the charger to help you secure the charging cable. The zip ties are a bit tricky to tighten tho.
An extra hole is located under the charger to help you remove it if the cutout is a little too tight.
Feel free to remix this design, the STEP file is available in the downloads.
Have a nice day and happy printing!
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (0)