Base for JP Performance G3V10

Base for the JP Performance G3v10. This allows you to display your Golf (for example, in your showcase) at an angle.

For attachment, simply snap the double nub on the underside into the screw holes of the camber adjusting screw.

It is best to print the base on the surface where the car will later be attached.Essentially upside down. Designed in two parts to make printing and assembly as easy as possible.If necessary, a few strategically (carefully) placed double-sided adhesive strips will help.

The shorter arm of the double nub then secures the rear axle and the longer arm the front axle.

It is recommended to print the whole thing in 0.20mm QUALITY, but draft mode is also suitable for those who are in a hurry.

If the base is too high for you, you can trim some off at the bottom in the slicer.You can also mirror the base, then the car will be tilted in the other direction.

Future models will also have a corresponding base, if I can get my hands on it.

And yes, the bumper, headlights, and spoiler on the Boost Wars are still missing from the images because I'm still working on them.

Feel free to ask me any questions.